Product Details

AUTOFIBER [HOLEY CLAY MITT] PERFORATED DECON MITT (8.5″ x 6″) – 1 PACK

• Perforated clay surface cuts through contaminants.
• Large working surface for fast and efficient decontamination.
• Fine-grade clay minimizes the risk of paint marring.
• This clay decontamination mitt features small drainage holes that effectively lift and flush away contaminants from your vehicle’s paint surface while removing embedded contamination.

Apply lubrication generously and continuously to both the mitt and the paint surface. Before first use, rub the clay surface on glass with adequate lubrication to properly break in the clay layer.

Pack Quantity: 1

Size: 8.5″ x 6″

Weight: 300 GSM

Blend: 75/25

Material: Mixed

Edge Type: Banded

Application

For optimal surface preparation, use Nanolex Clay Lube as the lubricant.

DIRECTIONS

Use ONLY on a cool, thoroughly cleaned surface. DO NOT use on surfaces below 12°C (54°F) or above 65°C (149°F). ALWAYS perform the break-in procedure before first use (see details below). ALWAYS test on an inconspicuous area before initial use to ensure compatibility with the surface.

1. Wash and rinse the vehicle thoroughly.
2. Spray Nanolex Clay Lube directly onto the area to be decontaminated.
3. Using light pressure, glide the Holy Clay Mitt over the lubricated surface, working one section at a time.
4. Start with the roof, then move to the hood, trunk, and finally the sides of the vehicle.
5. Rinse the vehicle with clean water.
6. Dry all surfaces using a clean, dry microfiber towel.

NOTE

• Adequate lubrication is critical when using the Holy Clay Mitt.
• Water alone is NOT an adequate lubricant.
• DO NOT use with a rotary polisher.
• The Holy Clay pad is not resistant to solvents.
• Remove grease, tar, and other heavy contaminants from the surface before application.