Description

Product details

The NANOSKIN AUTOSCRUB System achieves professional results quickly and easily due to its innovative rubber / polymer technology. Nanoskin’s Autoscrub pad replaces the clay bar step. The use of the decontamination pad is done with the double-action orbital polisher or directly by hand. It easily removes paint “smokes” (paint overspray), water marks, fresh tree sap, brake dust and other contaminants from surfaces such as paint, glass, moldings and plastics. Unlike the clay bar, the Autoscrub pad can be cleaned by simply rinsing the rubber surface to remove contaminants that lodge on the surface. Also, if you drop the Autoscrub pad on the floor, you only have to rinse the surface well so that you can reuse the pad, which is impossible to do with the clay bar. The Autoscrub glides easily over surfaces allowing excellent control and ease of use, unlike the clay bar which must be constantly manipulated / reformed.

Application

* To properly prepare the surface, use Nanoskin Glide lubricant.

 

DIRECTIONS:

Use ONLY on a cool, well-cleaned surface. DO NOT work on a surface with a temperature below 12 ° C or above 65 ° C. ALWAYS perform the “Break-in” step before very first use (see below for details). ALWAYS work an inconspicuous area for the first use, in case of unexpected adverse effects on the surface.

Mix 1 oz of Nanoskin Bubble Bath Wash & Shine Shampoo per gallon of water.
Rinse the surfaces with water before soaping the car to remove as much dirt as possible without contact.
Wash and rinse, one section at a time, with the Nanoskin Autoscrub Wash Mitt, applying light pressure.
Start with the roof, and work on the hood, the suitcase and finish with the sides of the car.
Rinse the car with water.
Dry surfaces with a clean, dry microfiber.

 

NOTE:

Sufficient lubrication is crucial for the use of the Nanoskin Autoscrub.

* Water alone is not an adequate lubricating solution.

* DO NOT use with a rotary polisher

* The Autoscrub pad is not resistant to solvents.

* Remove fatty substances and tar from surfaces before application.

 

Practical tip:

The Autoscrub pad includes a protective coating to ensure product stability during transport.

To perform the “Break in” step, lubricate the Autoscrub pad with your lubricant of choice.

Then lubricate a portion of a window (windshield or other). Rub the Autoscrub for a period of 30 to 60 seconds against the glass with a circular motion (this step can be done by hand or by machine). You will see a soapy foam coming out of the pad, this is the protective coating that comes out of the pad.

Do not use your Nanoskin Autoscrub until the cured rubber is soft and slightly tacky to the touch.

Cold temperatures can harden the pad, warming up the pad before use.